|
 Then we punched two holes in each fin to accommodate our supply and return tubes, using the actual fin as the return tube carrier, and included the tube as part of the assembly. This enables the installer to pipe Heating Edge in parallel, to pipe it as a supply and return or to use either of the tubes as a single supply. Capacities vary according to the piping arrangement used and the cover styling selected.
 Finally we designed a simple back plate and cover design, which not only looks attractive but simplifies the installation by doing away with brackets, cradles, dampers and damper vanes. The installer is left with three pieces: the core, the back plate and the cover. What can be easier than that?
When we finished, we found that we had designed a product which answered many of the comments and suggestions that we had been hearing for years from both trade and mechanical contractors alike. We liked what we saw and we know that you will to.
Quiet, efficient, rugged and cost effective, the Heating Edge gives you more heat, more savings and more peace of mind.
|
